Model-DGCH - 25
It's universal design enables it to calibrate both plunger and lever DTI's (Dial Test Indicators). It can also be used for calibration of bore gauges. The unit also determines gauge hyteresis which is not possible using conventional gauge blocks. This dial gauge calibrator can be used in calibration laboratories and also be used for roaming shop floor gauge calibration checks as it is a portable device. The test is performed by comparison with the master gauge. The calibrator uses the Abbe's principle.

SPECIFICATIONS : 25 mm travel covering the majority of common indicators Accepts lever indicators with stylus up to 40 mm long Computer interface for efficient calibration reports. Plunger dials with 8mm or 3/8” shank can be tested. Bore gauges up to 150 mm can be checked. The standard Kit incorporates, Cary case ModelDGC-25 calibrator Master gauge (Baker Electronic Dial Gauge ED1) RS 232 cable to transfer output to computer with software Magnifying glass 3/8” to 8 mm stem mounting sleeve. Bore Gauge holding bracket and extension rod. For more details and enquiry please contact.

Range 0-25mm
The dial gauge calibration tester series “ V ” is one of the most efficient design, specially to check dial indicators, dial test indicators (Lever type dials) and cylinder bore gauges reading 0.01mm. As an additional feature this is a 2 in 1 calibrator which can also calibrate 0.001mm reading dial indicators having short range. Accuracy of the measuring equipment should be 3 to 10 times more accurate than the indicators to be tested. For this, large micrometer head with widely spaced graduation lines for better readability giving direct reading of 0.002mm and having a vernier scale with 9/10 divisions which gives a least count of 0.0002mm is provided. This is suitable for testing 0.01mm and 0.001mm dial gauges, giving an additional feature.

SPECIFICATIONS
Range :- 25mm
Micrometer :- Accuracy plus/minus 0.002 mm, having direct reading 0.002mm and L.C. 0.0002 mm.
Base :- Heavy cast iron to achieve rigidity. Size- 150 x 205 x 50mm
Height :- 400mm aprox.
Mounting :- 8 dia, and 6 for dials and dial test indicators, & up to 18mm stem dia. bore gauges.

ACCESSORIES
Bracket to mount 8mm shank Electronic Probe L.C. 0.0001mm above the dial under test. For more details and enquiry please contact.